دليل شبك تثبيت الحراريات لمشاريع الأفران والبطانات

الدليل الإنجليزي الأصلي

Anchoring mesh is part of the lining system, not a stand-alone accessory

Buyers in furnace or refractory projects sometimes order anchoring mesh by habit without defining the lining thickness, anchor layout, or operating cycle. But mesh selection depends on whether the part is supporting castable, holding fiber, or working with other anchors inside a thermal system.

Alloy and geometry should follow the heat cycle

The mesh may face oxidation, repeated heating and cooling, or installation stress before the furnace even starts operation. Buyers should confirm alloy, wire diameter, opening, and fabricated form based on the refractory design rather than reusing a generic mesh item.

RFQs should align with the lining design package

• State furnace zone, temperature cycle, and lining type.
• Confirm whether the mesh is supplied in sheets, formed parts, or cut pieces.
• Ask how the supplier controls shape, identification, and packing for site installation.

Anchoring mesh works best when it is sourced as part of the refractory system design, not as a last-minute hardware item.